
GSM-4/GSM-5
SATEL
34
Set modem format [SMS mod. format]
The SMS message sent to the module to set the modem format must have the following
form:
xxxxxx=yy
, where "xxxxxx" is the control command and "yy" is the modem format
code (see Table 1 p. 29). Having received such an SMS message, the module will
change the modem format.
Call to service [SMS "service"]
The control command can start the remote modem communication between the
INTEGRA control panel and the D
LOAD
X program, or between the CA-64 control panel
and the D
LOAD
64 program (this applies to the CA-64 control panel firmware version
1.04.03 or newer, and the D
LOAD
64
program version 1.04.04 or newer).
The SMS message sent to the module may have the following form:
xxxxxx=yyyy.
or
xxxxxx=yyyy=
, where "xxxxxx" is the control command and "yyyy" is the computer
telephone number with which the control panel is to establish communication. If no
telephone number is given, the control panel will connect to the number programmed in
its memory. If the module receives an SMS message initiating connection with the
INTEGRA control panel, and the access to D
LOAD
X program is blocked, the module will
send an appropriate SMS message to the telephone number programmed using the
„SMS acknowl. No” function (see: p. 35).
Call to user [SMS "user"]
The control command can start the remote modem communication between the
INTEGRA control panel and the G
UARD
X program, or between the CA-64 control panel
and the G
UARD
64 program (this applies to the CA-64 control panel firmware version
1.04.03 or newer, and the G
UARD
64 program version 1.04.04 or newer).
The SMS message sent to the module may have the following form:
xxxxxx=yyyy.
or
xxxxxx=yyyy=
, where "xxxxxx" is the control command and "yyyy" is the computer
telephone number with which the control panel is to establish communication. If no
telephone number is given, the control panel will connect to the number programmed in
its memory.
DTMF control
The module can be remotely controlled by means of the keypad of telephone from which
communication with the module has been established. You can program the codes which, if
entered will (given in parentheses are the names of corresponding functions in the module
service mode):
bypass inputs ("DTMF bypass IN1" ... "DTMF bypass IN4", "DTMF bypass all");
unbypass inputs ("DTMF unbyps.IN1" ... "DTMF unbyps.IN4", "DTMF unbyps.all");
check status of inputs ("DTMF check inps");
activate outputs ("DTMF OT1 on" ... "DTMF OT3 on", "DTMF OT123 on");
deactivate outputs ("DTMF OT1 off" ... "DTMF OT3 off", "DTMF OT123 off");
switch over status of outputs ("DTMF switch OT1" ... "DTMF switch OT3");
check status of outputs ("DTMF check outs").
The codes used for DTMF remote control must consist of 4 digits.
The DTMF tones may get distorted during transmission, which will impede the control.
Design of some telephones requires activation of the DTMF feature.