
GSM-4/GSM-5
SATEL
22
The data will be written to the module after the OK button is pressed. Use the ESC button to
exit the function without saving any changes.
Pressing the CHANGE and NEXT buttons simultaneously will delete at once all the value
preprogrammed for the given parameter.
6.2 D
LOAD
10 program
The D
LOAD
10
program version 1.00.039 is required for programming and configuration of the
GSM-4 module version 4.14 and the GSM-5 module version 5.14. The program is delivered
free of charge with the device. Communication between the program and the module can be
effected locally or remotely. The module with factory default settings can only be
programmed locally.
The program installation file can be found on the CD delivered with the module. You can also
download it from the www.satel.eu website. The D
LOAD
10
program can be installed on the
computers running the Windows XP/VISTA/7 operating system.
Access to the program is protected with a code (password). During its first start-up, the
program is accessed with the factory default code: 1234 (you do not need to enter it, just click
on the "OK" button).
It is recommended that the factory access code be changed. It can be replaced with
any sequence of 16 alphanumeric characters.
6.2.1 Local programming
1. Connect the module RS-232 port with the computer serial COM port (see: Fig. 10).
Fig. 10. Computer connection to the module RS-232 port. Shown on the left is the PIN-5 plug
to be connected into the module connector. Shown on the right is DB-9 female plug (solder
side view). A ready cable is offered in the DB9F/RJ-KPL set.
2. In the D
LOAD
10
program, "File" menu, first select "New device", and then "GSM-4/5/LT