
SATEL GSM-4/GSM-5
29
call will be made by the GSM telephone and the module will report an analog telephone
line trouble.
Show dialed numbers [Show dialing] –
if this option is enabled, the numbers dialed by
devices connected to the telephone line output are displayed.
Show tel. line trouble [Show TL failure] –
if this option is enabled, the "Phone line loss"
message will appear on the display in the event of analog telephone line trouble.
OUT2 output - reporting trouble [OT2 - mon.trbl.]
– if the option is enabled, the OT2
output indicates the reporting trouble.
OUT3 output - tel. line trouble [OT3 - t.l.trbl.]
– if the option is enabled, the OT3 output
indicates the analog telephone line trouble.
If the "OT2 - mon.trbl." or "OT3 - t.l.trbl." option is enabled, the selected output cannot
be controlled.
OUT4 output - only GSM trouble [OT4 - only GSM]
– if this option is enabled, the OT4
output indicates only a problem with logging into the GSM network. If the option is
disabled, the output indicates a problem with logging into the GSM network and a
telephone line trouble. The problem with logging into the GSM network can be caused by:
missing SIM card,
entering a wrong PIN code,
missing or damaged antenna,
unavailable GSM network (out of range),
telephone
damage.
Fax/modem
– if this option is enabled, the module can be used as an external modem. The
module starts working in the modem mode on receiving the AT command, and stops
working in this mode when the DTR signal is lost.
Do not enable the "Fax/modem" option, if the module is working in conjunction with the
INTEGRA control panel (the control panel is connected to the module RS-232 port).
Switch line if trouble [Trbl.-switch l.]
– if this option is enabled, the module will be
automatically switched over to the backup communication path in case of the primary path
trouble.
No voltage on T-1/R-1 if GSM trouble [Turn off TLvolt]
– if this option is enabled, voltage
on the telephone line terminals will be turned off in case of the GSM telephone trouble.
Generate routing signal [Routing signal]
– if the option is enabled, the connection setup is
audibly signaled.
Modem format
– the transmission standard of the modem with which the GSM module
communicates. The format code is to be entered as 2 digits, according to the table below.
format code
modem format for GSM u-blox
LEON-G100 telephone
00 auto
04
2400 bps V.22bis
05
2400 bps V.26ter
06
4800 bps V.32
07
9600 bps V.32
12
9600 bps V.34
68
2400 bps V.110/X.31 flag stuffing
70
4800 bps V.110/X.31 flag stuffing
71
9600 bps V.110/X.31 flag stuffing
Table 1. Modem format codes for the GSM u-blox LEON-G100 telephone.