
SATEL GSM-4/GSM-5
49
are on the list of authorized numbers (see: "Tel.No 1-32 begin." p. 30) – enable the
"All.tel.control" option (see: p. 36).
To use the control, do the following:
1. Call the GSM module telephone number, wait until the programmed ringing time elapses
and after hearing 3 short beeps enter the 4-digit control code. Depending on the function
executed after entering the code, you can hear the following sounds in the telephone
receiver:
deactivating output / all outputs:
3 short beeps
;
activating output / all outputs:
4 short and 1 long beeps
;
bypassing or unbypassing input / all inputs or information on the status of inputs:
a sequence of 4 sounds
in which successive sounds illustrate the status of
consecutive inputs:
short beep
– input unbypassed,
long beep
– input bypassed;
information on the status of outputs:
1 short beep
– OT1 output activated,
2 short beeps
– OT2 output activated,
3 short beeps
– OT4 output activated,
4 short and 1 long beeps
– all three outputs are deactivated.
If a wrong control code is entered (which is unknown to the module),
2 long beeps
will be
generated by the module.
If you make a mistake when entering the control code, press the [*] or [#] key and re-
enter the code. Entering a wrong code three times will result in loss of connection with
the module.
2. Enter the next control codes or terminate the connection.
7.1.2 Using SMS
Program the control commands (see: section "SMS control" p. 32).
If the control availability is to be limited to the telephones whose numbers:
have been programmed in the module (see: "Tel.1-4 for mess." p. 38, "SMS acknowl.
No" p. 35 and "Mon.trbl.tel.nr" p. 43) – enable the "Msg.tel.control" option (see: p. 36);
are on the list of authorized numbers (see: "Tel.No 1-32 begin." p. 30) – enable the
"All.tel.control" option (see: p. 36).
If module is to confirm execution of the control command by means of SMS message,
program the following items:
telephone number to which acknowledgements will be sent by the module (see: "SMS
SMS center number (see: "SMS centre No" / "SMS centre SIM2" p. 31).
To use the control:
1. Send the SMS message containing a control command to the telephone number of GSM
module.
The control command may be just a fragment of the SMS message, but it must be
among the first 32 characters. This makes it is possible to write the control command,
including the comments, to the telephone memory and send the whole to the module.
Several control commands may be included in one SMS message.