
GSM-4/GSM-5
SATEL
14
9. Using the suitable function, enter the PIN code(s) of SIM card(s) (if required by the SIM
card).
10. Turn off power supply of the module.
11. Insert the SIM card into the socket (see: Fig. 9).
1
2
3
4
5
6
Fig. 9. Installing the SIM card.
12. Turn on power supply of the module
.
Logging the telephone into the GSM network may
take a few minutes.
If the SIM card does not accept the PIN code, first the "Bad PIN, go on ? Wait…",
information is displayed, followed by the "Bad PIN, go on ? ESC=Stop" information (in
the GSM-5 module, the STAT LED will additionally indicate which PIN code is invalid).
The next attempt to use the PIN code will take place after 60 seconds. After the third
attempt to use the wrong PIN code, the SIM card will be blocked. To unblock the SIM
card, insert it into a mobile phone and enter the PUK code.
6. Programming
You can configure the module using the buttons located on the electronics board or the
computer with suitable software (locally and remotely).
6.1 Service mode
Programming the module by means of buttons on the electronics board is possible due to the
service functions, available in the service mode menu. To start the service mode, press and
hold down simultaneously the CHANGE and NEXT buttons. If required by the module, enter
the code to get access to the service mode (see "Service code" p. 27).
If no button is pressed for about 1 minute, the module will exit the service mode
automatically.
When the service mode is running, the control of inputs and outputs by means of
buttons is impossible.