User manual
VDC-295IDH
_________________________________________________________________________________
- 41 -
View angle setup
Flip:
Off, 90°, 100°, 110°, 120°, Auto
(not for camera VDC-295ID).
On, Off
(only for camera VDC-295ID)
Off:
The dome camera flips vertically up to 90°.
90°, 100°, 110°, 120°: The picture flips digitally, if the camera pans vertically
over the view angle.
Auto: If the camera is at floor level directly above the moving object, it stops.
Please release the joystick handle immediately and pull it down
to start the auto-flip function. If you are in panning mode, it is
recommended to use the “Auto” setting.
Tilt over angle:
This option is used to set the limit of the horizontal view angle so that the trim ring or
the ceiling of a room does not obstruct the horizontal image when zooming out (wide
angle).
ON: In some installation is is desirable for the dome camera to be able to see above
the horizon. When this option is chosen, the dome camera will tilt up over the horizon
(approx. 10°). When the lens is zoomed out, you can see the ceiling line. But when
the lens is zoomed in, the viewing angle is narrower and the ceiling disappears.
Without bubble:
The tilt range of the camera reaches up to the horizon so that the
picture shows parts oft he ceiling line.
With bubble: The tilt range oft he camera is limited to see below the horizon (-10°).
The over-angle is not sufficient to avoid ceiling obstructions. Please adjust the "Origin
Offset" of the tilt angle as described below.
