User manual
VDC-295IDH
_________________________________________________________________________________
- 22 -
7. Select
„End angle“. Press and hold the CTRL button while selecting the end position
with the joystick. The current panning position will be displayed. Release the CTRL
button to complete the selection of the end position. Alternatively, you may press IRIS
OPEN to display CTRL. Move to the desires position and zoom position. Press IRIS
CLOSE again and CTRL disappears. To adjust at 0.1° intervals, twist the joystick at
the pan field and the tilt field. To make adjustments in one-zoom-intervals, twist the
joystick at the zoom field.
8. Set
„Scan Dir“ to either CCW (counter-clockwise) or CW (clockwise).
9. Select
„Swap“. If set to „ON“, the start angle and the end angle are swapped.
10. Select
„Dwell time“.
11. Select
„Save“ and „Exit“ by pushing the joystick to the right. Alternatively, you may
press IRIS OPEN. Press ESC or IRIS CLOSE to exit the program without saving.
Press the HOME button to delete stored data in the angle field.
Setting the position using presets:
a. Before entering the auto scan menu, select a preset position as a start point for auto
scan.
Example:
Press the 2 + PRST
buttons and follow steps 1-4 (see above). Then press CTRL at
the start angle position. The current position will be displayed as a start position.
b. Save the adjustments and exit the menu.
c. In normal mode, select a preset to be the end point of the scan. Press 3 + PRST
and
then the scan button to enter the auto scan menu.
Move the cursor to „END ANGLE“.
Press CTRL at the end ang
le position. Then “Save” and “Exit” from the menu.
