Sam Sirius 830, Инструкция по установке и быстрому запуску

Страница: 21 / 72

Sirius 830 Installation Manual www.s-a-m.com Installation
Issue 2 Rev 2 Page 21 © 2016 SAM
5. Installation
5.1 Installing into a 19" Rack
The Sirius 830 has rack mount ears, for mounting into a 19" rack. Place the frame on a
suitably specified and installed rack shelf for extra stability.
1. Move the Sirius 830 so that the frame rear lines up with the front of the rack it will be
mounted in.
2. The Sirius 830 has a single door, that provides access to the rack mount mounting
points. The door must be opened and removed to expose the rack mount ears (see
section 5.1.1).
5.1.1 Opening the Door
The door is hinged on the left hand side so that you can access the inside of the frame.
To remove a latch guard and open the door:
1. Un-screw the captive screw on the right side of the guard, see Fig 8.
2. Take hold of the guard by the captive screw and carefully swing open the guard to the
left until the guard is at 90° to the door, the guard can then be pulled outwards and
away from the door. When re-fitting the guards, take care when inserting the two
prongs on the guard back into the location holes in the door.
3. Turn the two door latches counter clockwise to release the door catches.
4. Take hold of the door handle and open the door.
5.1.2 Removing the Door
1. With the door open unplug all the cable connections from the door PC.
2. Lift the door off its hinges and place it away from the rack.
The Sirius 830 is extremely heavy, between 73 kg (161 lbs) and 85kg (187 lbs) for a full
frame (without packaging and depending on modules fitted). When lifting the Sirius 830
into a 19" rack use the correct local Health and Safety lifting guidelines.
Note:
The two door latches have guards fitted which prevent them from turning. Remove the
guards before attempting to open the door.
Fig 8. Remove a Latch Guard