SafanDarley E-Brake Premium 100-3100, Инструкция по эксплуатации, Страница: 53 / 133

SafanDarley E-Brake
Working
Instruction manual SafanDarley E-Brake Premium 100-3100 100Pr 2019 53
Because the light guard is not active as safeguard, the maximum closing
speed of the upper beam is not allowed to be higher than 10 mm/s.
In this position the light guard is only active as safeguard during the first
part of the stroke of the upper beam (as far as the mute point)
At the mute point the light guard will be switched off.
In this position all the movements (back gauge and upper beam) start
when the foot pedal is pressed.
If the foot pedal is pressed, the upper beam will move downwards with
high speed (approach speed).
Because the light guard is active as safeguard during this part of the stroke
of the upper beam, the maximum closing speed of the upper beam is
allowed to be higher than 10 mm/s.
The light guard may not be interrupted during this movement of the upper
beam. If the light guard is interrupted the upper beam will immediately
stop and return to TDP.
At the mute point the movement of the upper beam will stop and the light
guard will be switched off.
If the foot pedal is pressed again, the movement downwards of the upper
beam will start again, but the speed is low now.
The light guard may be interrupted during this part of the movement.
Because the light guard is not active as safeguard during this part of the
stroke of the upper beam, the maximum closing speed is not allowed to be
higher than 10 mm/s.
Position 2:
One break mode
Light guard control, no blanking
Programmable one break mode
When there is no break for 30 seconds after the upper beam reached TDP,
the operator has to push the reset button to return to one break mode.
In this position can be chosen for one of the 3 following procedures:
In this position the light guard is during the whole stroke of the upper
beam active as safeguard.
In this position all the movements of the back gauge and upper beam start
when the light guard is interrupted and left 1x. (When switched into One
break mode the X-axis should, at the first time, be set in position by