SafanDarley E-Brake Premium 100-3100, Инструкция по эксплуатации, Страница: 105 / 133

SafanDarley E-Brake
Maintenance
Instruction manual SafanDarley E-Brake Premium 100-3100 100Pr 2019 105
9.3. MAINTENANCE
Regularly clean uncovered parts and oil these parts lightly after cleaning:

press brake table

top tool adaptation

bottom tool adaptation

tools

back gauge beam and back gauge fingers

support arms

grips and handles
Replace faulty parts in time.
Adjust the machine correctly before bending. Make a daily round around the
machine for maintenance purposes.
Contact SafanDarley B.V. for a servicing contract.
9.3.1. TAUTEN UPPER BEAM BELTS
The belts of the upper beam are checked by a sensor. In case the belts got loose
the sensor will interrupt the press brake control.
Turn the mode selector switch into position “Service”. In this position the brakes
of the main motors are released. After that, the belts can be tautened with a hex
key (size: 17 mm).
See the sticker next to the motors for the correct turning direction. The drive
belts are tautened by turning the shafts of the gearbox (above the motor). The
belts have to run properly between the belt guiding edges of the rolls.
Check carefully that the belts run properly between the belt
guiding edges of the rolls.
Put the mode selector switch back in position for production.
Push the reset button and then push the machine drive-on button.
9.3.2. CHECKING AND RE-ADJUSTING THE UPPER BEAM
GUIDES
When checking the tool alignment or the back gauge adjustment errors may be
found that make it necessary to re-adjust the upper beam guides.
!