4.6.2
Protocol transparency
Figure 4.37
Protocol Transparency
1.
Represents four LAN (Local Area Network) ports of the CFIP PhoeniX switch, as well
as WAN (Wide Area Port) connected to modem Ethernet interface;
2.
STP
– allows enabling/disabling Spanning Tree Protocol (STP) transparency by
passing through/filtering BPDU (Bridge Protocol Data Unit) frames on specified
ports (command line –
ethernet transparency STP
{enable | disable} {<port list> |
All}
);
3.
LACP
– allows enabling/disabling Link Aggregation Control Protocol (LACP)
transparency by passing through/filtering LACP frames on specified ports (command
line –
ethernet transparency LACP
{enable | disable} {<port list> | All}
);
4.
OAM
– allows enabling/disabling Operations, Administration and Management
(OAM) transparency by passing through/filtering OAM frames on specified ports
(command line –
ethernet transparency OAM
{enable | disable} {<port list> | All}
);
5.
By pressing
„Execute configuration”
changes made to the corresponding section
apply only for the local side CFIP PhoeniX. If
„Rollback on”
is selected, configuration
will be reverted in case erroneous configuration changes are applied.
4.6.3
Ethernet ingress/egress rate configuration
Figure 4.38
Ethernet ingress/egress rate configuration
1.
Following section allows configuring ingress and egress rates on available Ethernet
switch ports. In case ver.2 license with Ethernet rate limitation is applied, according
Ethernet limitation will be indicated as ingress rate for WAN port;
2.
Pressing
„Execute configuration”
applies changes made to the corresponding
section only for the local side CFIP PhoeniX. If
„Rollback on”
is selected,
configuration will be reverted in case of erroneous configuration changes applied;
3.
Writes to configuration file all the changes made on the whole page (command line
–
cfg write
);
4.
System returned -
in case of error or incorrectly entered parameter value, or other
problems on the whole page – the info message is being shown here. Otherwise it
says “Ok”.
CFIP PhoeniX Series TDM/IP Split Mount System Technical Description and Configuration Guide
•
Rev. 1.13
•
© SAF Tehnika JSC 2015
64