3.
Link –
shows whether link with appropriate port is established. If link is off,
according field will be shown in red;
4.
Duplex (actual) –
shows if port is currently operating in full or half duplex mode;
5.
Rx flow –
shows if ‘flow control’ is enabled or disabled for ingress traffic;
6.
Tx flow –
shows if ‘flow control’ is enabled or disabled for egress traffic;
7.
Rx state –
shows if ingress activity is allowed;
8.
Tx state
– shows if egress activity is allowed;
9.
Speed (set) –
shows current operation mode of each port and allows to set manual
speed setting (10hdx/10fdx/100hdx/100fdx/1000fdx) (command line –
ethernet set
<1 | 2 | 3 | 4> connection <auto | 10hdx | 10fdx | 100hdx | 100fdx | 1000fdx
>
);
10.
Ethernet flowcontrol –
allows manually disabling or enabling flow control for specific
port. Default option is auto (from autonegotiation). Uncheck “auto” in order to
enable manual force mode (command line –
ethernet flowcntrl
{forced <Ports> |
auto}
);
11.
By pressing
„Execute configuration”
changes made to the corresponding section
apply only for the local side CFIP PhoeniX. If
„Rollback on”
is selected, configuration
will be reverted in case erroneous configuration changes are applied.
12.
configuration will be reverted in case erroneous configuration changes are applied.
4.6.1
Link state propagation configuration
Link state propagation (LSP) functionality allows shutting down specified LAN ports if synchronization
loss events occur so that customer-premises equipment (CPE) is able to apply necessary changes
promptly.
Figure 4.36
Link state propagation configuration
1.
LSP ports –
enables LSP (Link State Propagation) on selected LAN ports (command
line –
ethernet rps ports
<ports>
);
2.
LAN auto recovery* (0..600) sec –
synchronization loss timeout after which port is
reenabled even if link synchronization is still lost, otherwise timout is ignored. If
parameter is set to “0”, port will not be reenabled until link synchronization is
recovered
(command line –
ethernet rps time
<tm1> <tm2>
<tm3>
);
3.
SyncLoss keepalive timeout (0..10) sec –
LAN port shutdown timeout after
synchronization loss and synchronization recovery events (command line –
ethernet
rps time
<tm1>
<tm2>
<tm3>
);
4.
LSP startup timeout (0.
.
3600) sec
– LSP activity timeout after management CPU start
up and configuration script execution. During this period synchronization events are
ignored (command line –
ethernet rps time
<tm1>
<tm2> <tm3>
);
5.
SNMP traps –
SNMP trap will be sent if enabled. Note that SNMP trap address
should be configured in SNMP configuration page (command line –
ethernet rps
trap
<on|off>
);
6.
By pressing
„Execute configuration”
changes made to the corresponding section
apply only for the local side CFIP PhoeniX. If
„Rollback on”
is selected, configuration
will be reverted in case erroneous configuration changes are applied.
CFIP PhoeniX Series TDM/IP Split Mount System Technical Description and Configuration Guide
•
Rev. 1.13
•
© SAF Tehnika JSC 2015
63
