Figure 4.21
Advanced protection configuration
1.
Protection switch
– temporarily switches IDU to active or standby state (command line –
prot
{active|standby}
);
2.
Force state
– permanently switches IDU to active or standby state until force state is disabled
by selecting ‘Off’ (command line –
prot force
{active|standby|off}
);
3.
Standby time
– allows specifying Standby time (in range 1 – 15sec) for Standby state. IDU will
remain for this time slot in Standby state during forcing it to another state (command line –
prot time standby
[<0...15 sec.>]
);
4.
Activetry time
– allows specifying Active try time (in range 1-15sec) for Activetry state. IDU
will remain for this time slot in Activetry state during forcing it to another state (command
line –
prot time activetry
[<0...15 sec.>]
);
5.
By pressing
„Execute configuration”
changes made to the corresponding section apply only
for the local side CFIP PhoeniX. If
„Rollback on”
is selected, configuration will be reverted in
case erroneous configuration changes are applied.
6.
Writes to configuration file all the changes made on the whole page (command line –
cfg
write
);
7.
System returned -
in case of error or incorrectly entered parameter value, or other problems
on the whole page – info message will be displayed here. Otherwise it says “Ok”.
4.4
System Configuration
The system configuration window provides the configuration of web access, telnet and FTP
interfaces; allows changing system name, web data refresh time and system time.
Additional user management commands in Telnet/serial interface
Command
Description
prot status
[remote|alternate|altrem|all]
Shows protection status of particular IDU, as well as of any
or all units involved in 1+1 configuration
prot alarms
Shows protection alarm status
prot trace
Traces protection state changes by printouts on terminal
prot ext statistics
Shows protection information exchange quality statistics
between local and alternate IDU
prot ext statistics clear
Clears all previous exchange quality statistics
CFIP PhoeniX Series TDM/IP Split Mount System Technical Description and Configuration Guide
•
Rev. 1.13
•
© SAF Tehnika JSC 2015
54
