Sacmi Imola CHS Series, Инструкция по эксплуатации

Страница: 59 / 116

062AZ005A
SAFETY EQUIPMENT AND PRECAUTIONS 3
3-11
3.5 OPERATION, ADJUSTMENTS AND MAINTENANCE
3.5.1 GENERAL STANDARDS
E0001
WARNING!
Never check, perform maintenance or attempt to repair machinery while it is in motion.
Use clearly visible signs or tags to inform workers.
E0007 E0014
WARNING!
Before performing any operations on the machine, including the replacement of components of the control panel and/
or electrical cabinet, the maintenance staff must shut off the electricity supply by using the main switch located on
the control panel. This switch should then be locked out with a padlock so that the machine cannot be accidentally
started up. Remove and personally hold on to the keys to the locks.
E0007
WARNING!
The electrical cabinets and junction boxes installed on-board the machine contain live parts.
Specific tools need to be used to access as per the requirements in standard EN 60204-1. Only qualified personnel
authorized to access live parts should be given this tool.
When the electrical control cabinet is energized, qualified personnel can only re-arm the protective devices for the
electric circuit.
E0007
WARNING!
Wherever “plug-outlet” connections are present, whether they are in the electrical control cabinets or junction boxes
on-board the machine, they are to be disconnected only with the machine stopped and after shutting off power from
the supply mains.
E0007
WARNING!
Specific tools need to be used to connect and disconnect wires attached to “spring” terminals.
E0004
WARNING!
Only SACMI genuine spare parts may be used. If the customer uses safety components (tubes, interlocks, switches,
etc.) supplied by other manufacturers or does not install them correctly, SACMI shall no longer be held responsible
for safe machine operation.