Rosemount OCX 8800, Инструкция по эксплуатации

Страница: 56 / 266

Instruction Manual
IM-106-880, Rev 2.1
April 2017
OCX 8800
3-4
Figure 3-2. OCX 8800 Defaults -
Fieldbus Electronics
INITIAL POWER UP
Allow adequate time (approximately 60 minutes) for the heaters to begin
operation and for the OCX 8800 to reach normal operating temperature on
power up. Normal operating temperature for the O
2
cell is 736°C. Normal
operating temperature for the combustibles cell is 300°C. The normal sample
line temperature is 170°C. During this time the eductor air solenoid will remain
closed so no sample is pulled through the analyzer. When the OCX reaches
operating temperature the solenoid will energize, eductor air will begin to flow,
and the unit will begin normal operation.
SET TEST GAS VALUES
Use Field Communicator or the optional LOI to set test gas values for
calibration. Refer to Section 4, Using the LOI or Section 6, Field
Communicator for more information.
Setting Test Gas Values with the Field Communicator
1. Use the 375 Field Communicator software to access the HART menu.
2. From the DETAILED SETUP menu, select CAL SETUP .
3. From the CAL SETUP menu, select O2 CAL PARAMS or COe CAL
PARAMS .
4. From O2 CAL PARAMS , select O2 HIGH GAS . Enter the percent O
2
used for the high O
2
test gas.
5. From O2 CAL PARAMS , select O2 LOW GAS . Enter the percent O
2
used for the low O
2
test gas.
6. From COe CAL PARAMS , select COe Test Gas . Enter the CO
concentration (ppm) used for COe test gas.