Rosemount OCX 8800, Инструкция по эксплуатации

Страница: 172 / 266

Instruction Manual
IM-106-880, Rev 2.1
April 2017
OCX 8800
8-8
Electronics package failure Check power supply voltage and compare with line voltage. Replace electronics
package if they do not agree within 5%.
Electronics housing exposed to high ambient
temperature Insulate housing from source of high temperature and/or install cooling fan to remove
heat from housing. Perform Reset procedure in Section 3, Configuration and Startup to
continue operation.
Unit powered down during calibration parameter
storage Perform Reset procedure in Section 3, Configuration and Startup. Recalibrate the OCX
and check/trim analog outputs.
Sensor housing exposed to high wind and/or
extreme cold temperatures Install sensor housing flange insulator (PN 6P00162H01).
Sensor housing exposed to high wind and/or
extreme cold temperatures Install sensor housing flange insulator (PN 6P00162H01).
Sensor housing exposed to high wind and/or
extreme cold temperatures Install sensor housing flange insulator (PN 6P00162H01).
High noise or voltage fluctuations in power
supply
AC power line frequency is outside the usable
range of the OCX universal power supply
Check power supply for line noise or voltage fluctuations. Install power line filter kit
(PN 6A00171G01) or high quality line filter for input power.
Correct power supply frequency. AC power line frequency must be between 50 and
60 Hz.
Electronics package failure Check power supply frequency with a calibrated oscilloscope or frequency meter and
compare with line frequency. Replace electronics package if they do not agree within
1 Hz.
High noise or voltage fluctuations in power
supply Check power supply for line noise or voltage fluctuations. Install power line filter kit
(PN 6A00171G01) or high quality line filter for input power.
Table continued on next page
Line Voltage Low (AC power line voltage below minimum, < 85 VAC)
Probable Cause Recommended Corrective Action
High noise or voltage fluctuations in power
supply Check power supply for line noise or voltage fluctuations. Install power line filter kit
(PN 6A00171G01) or high quality line filter for input power.
Line Freq Error (AC power line frequency out of usable range, < 45 Hz or > 66 Hz)
Probable Cause Recommended Corrective Action
High noise or voltage fluctuations in power
supply Check power supply for line noise or voltage fluctuations. Install power line filter kit
(PN 6A00171G01) or high quality line filter for input power.
SB Temp Low (Sample block heater temperature low, < 150ºC)
Probable Cause Recommended Corrective Action
High noise or voltage fluctuations in power
supply Check power supply for line noise or voltage fluctuations. Install filter power line kit
(PN 6A00171G01) or high quality line filter for input power.
COe Temp Low (Combustion sensor heater temperature low, < 290ºC)
Probable Cause Recommended Corrective Action
Flash PROM failure Replace electronics package.
O2 Temp Low (Oxygen sensor heater temperature low, < 710ºC)
Probable Cause Recommended Corrective Action
EEPRM Chksm Fail (Non-volatile parameter storage corrupted)
Probable Cause Recommended Corrective Action
Board Temp Hi (Electronics temperature maximum exceeded, > 85ºC)
Probable Cause Recommended Corrective Action