Rohde & Schwarz NRP18A, Руководство пользователя

Страница: 15 / 165

Preparing for Use
R&S
®
NRPxxA(N)
15 User Manual 1177.6017.02 ─ 05
To disconnect from the DUT
►
NOTICE! Risk of damaging the center pin of the RF connector. Always rotate only
the hex nut of the RF connector. Never rotate the power sensor itself.
Carefully loosen the union nut at the front of the RF connector of the sensor and
remove the sensor.
3.5 Connecting to a Computer
For operating the power sensor, you can choose from various possibilities. For details,
see
Chapter 5, "Operating Concepts" , on page 29.
You can establish the connection using one of the following interfaces:
●
Host interface
●
LAN interface, if the power sensor is a LAN power sensor
Contents:
● Setting Up a USB Connection .................................................................................15
● Setting Up a LAN Connection ................................................................................. 18
3.5.1 Setting Up a USB Connection
You can connect a R&S NRPxxA(N) to a computer using the host interface and control
it as described in
Chapter 5, "Operating Concepts" , on page 29.
Further information:
●
Chapter 11.1, "Remote Control Interfaces and Protocols" , on page 133
3.5.1.1 Simple USB Connection
All R&S NRPxxA(N) power sensors can be connected to a computer by a USB inter-
face and controlled by a supported software or a remote program.
Required equipment
●
R&S NRPxxA(N) power sensor
●
R&S NRP
‑
ZKU cable
Connecting to a Computer