PRT32 v1.0 fv74.7 Rev. A EN
7/3/2009
_________________________________________________________________________________________
Page 22 of 29
Example 2: Delete a user with ID=45 - programming sequence:
[9][0][4][5][#]
•
Read your MASTER card
•
The reader enters User Programming mode (LED OPEN is on and its LED
STATUS
is on and red)
•
Press [9]
•
LED SYSTEM
starts flashing
•
Press [0]
•
Press [4]
•
Press [5]
•
Press [#]
•
Command is completed
The reader deletes the user with ID=45 from its memory, however, it remains in
User Programming mode, so that you may use your next desired programming
command.
8.
Acoustic and optical signals in Offline mode
Acoustic signals in Offline (stand-alone) mode
Signal Symbol
Description
One long signal
-
Error - unknown identifier, access denied.
Two long signals
- -
Attempt to assign the same function for two different
input lines.
Three short beeps
* * *
Command successfully completed (OK signal).
Two short beeps
* *
Prompt signal, the reader is waiting for the next part of
the command to be entered. This signal is intended to
encourage the programmer to proceed with next
programming steps.
One long signal
continuously
repeated
- - - - - -
… and
so on
Memory contents corrupted or either MASTER or
INSTALLER card not programmed - Memory Reset is
necessary. This signal is accompanied by the steady lit
LED SYSTEM .
Legend:
-
single long audible signal,
*
single short audible signal (beep)
LED indications in Offline (Stand-alone) operation mode
LED
STATUS
LED
OPEN
LED
SYSTEM
Description
Green — —
The reader is in Disarmed state now.
Red — —
The reader is in Armed state now.
Red Green —
The reader is in User Programming mode.
