PRT32 v1.0 fv74.7 Rev. A EN
7/3/2009
_________________________________________________________________________________________
Page 10 of 29
which reader uses for user’s identification depends on the actual Identification
Mode. The PRT32 enables following Identification Modes:
•
Card or PIN, the reader requires card or PIN, only one of them is necessary for a
successful identification
•
Card and PIN, the reader requires card and PIN, both are necessary for a
successful identification
Notes:
1.
When Card and PIN mode is active, always first read a card and then enter a
PIN.
2.
The Identification Mode can be set separately for primary and secondary
reader.
6.4.
Armed and Disarmed Modes
In Stand-alone mode reader may be Armed or Disarmed. The actual mode of the
reader is indicated on the dual color LED STATUS
, which lights in red for Armed
and green for Disarmed. The actual mode in which reader is can be indicated on an
output line configured to option
Disarmed Mode
. Such a configuration allows the
output line to be used to control an arming mode of an alarm system to which
reader is connected to or to switch on/off some other auxiliary system or device
(e.g. heating, lights etc.). In general, the reader’s Armed/Disarmed states have no
effect on door unlocking, unless the
Access disabled when reader armed
option
will be enabled. With this option activated, access to the supervised room my be
granted only when reader operates in Disarmed mode.
Using the option mentioned above the TOGGLE and TOGGLE LTD users are capable
to enable or disable access to the supervised room, also it allows automatic access
locking upon a reader entering the Armed mode.
Note: Although the Armed and Disarmed modes of the reader were originally
designed for integration with the alarm system, they can be successfully used for
any other purpose which requires an on/off control method (light control, heating
control etc).
Note: Upon powering on, the PRT32 automatically returns to the arming mode
(Armed or Disarmed) it was in before powered off. Also, the reader returns to its
original Armed/Disarmed state after leaving the programming mode. After Memory
Reset controller always enters the Armed mode.
6.5.
Arming and disarming of a reader
The action changing the reader from Armed to Disarmed and back (i.e. reverse
direction) is referred to hereinafter as “rearming”. The term “arming” should be
understood here as the action effecting a switch into the Armed mode, whereas the
term “disarming” a switch into the Disarmed mode.
Reader rearming operation can be done by TOGGLE or TOGGLE LTD users. The
