Roger PRT32, Инструкция по установке и программированию, Страница: 18 / 29

PRT32 v1.0 fv74.7 Rev. A EN 7/3/2009
_________________________________________________________________________________________
Page 18 of 29
C5 0 – 7
Function settings for the REL1 output on the XM-2 module (when in Full stand-
alone mode) or for the CLK line (when in Simple stand-alone mode):
[0] – Line off , line is disabled
[1] – Door Contact (input), line shorted to supply minus indicates that
corresponding door is closed
[2] – Exit Button (momentary input), shorting the line with supply minus unlocks
a door for time defined by Door unlock time
[3] – Arming Disabled (input), when line is shorted with supply minus reader will
reject any attempt to go into Armed mode
[4] – Door Lock (output), output controls the door releasing device (an electric
lock or electric strike).
[5] – Disarmed Mode (output), line is triggered for the entire time when reader is
Disarmed
[6] – Door Alarm (output), line is used to indicate alarm, output is modulated
according to a detected alarm type, when more then one alarm exist output
indicates alarm with a highest priority.
[7] – Door Bell (output), whenever the door bell event occurs this output goes on
for approx. 5 seconds.
C6 0 – 7
Function settings for the REL2 output on the XM-2 module or for the DTA line,
assignments as above.
C7 0 – 3
Function settings for the IN1 line on the reader:
[0] – Line off , line is disabled
[1] – Door Contact (input), line shorted to supply minus indicates that
corresponding door is closed
[2] – Exit button (momentary input), shorting the line with supply minus unlocks
a door for time defined by Door unlock time
[3] – Arming Disabled (input), when line is shorted with supply minus reader will
reject any attempt to go into Armed mode
C8 0 – 3
Function settings for the IN1 line on the XM-2 module – assignments as for C7.
C9 0 – 3
Function settings for the IN2 line on the XM-2 module – assignments as for C7.
C10 0 – 1
The Identification Mode for primary (main) reader:
[0] - Card or PIN
[1] - Card and PIN
C11 0 – 1
The Identification Mode for secondary (auxiliary) reader:
[0] - Card or PIN
[1] - Card and PIN
C12 0 – 1
Option: Door alarm indication on internal buzzer
[0] – Disabled
[1] – Enabled
C13 0 – 1
Option: Access disabled when reader armed
[0] – Disabled
[1] – Enabled