PRT32 v1.0 fv74.7 Rev. A EN
7/3/2009
_________________________________________________________________________________________
Page 12 of 29
unlock time
.
Note: The LED OPEN is activated for the entire time when door remains
unlocked. When access to the room is denied, reader generates a long continues
beep.
The access to a room can be denied in following situations:
•
When the identifier is not valid (unknown)
•
When reader operates in Armed mode and the option
Access disabled when
reader armed
is active
•
When the identifier is a TOGGLE LTD type
•
When the identification doesn’t comply with the actual Identification Mode valid
on the reader (e.g. when Card and PIN mode was set on the unit but user
presented only card)
With option
Access disabled when reader armed
the TOGGLE or TOGGLE LTD
users may use their identifiers (card, PIN or both when Card and PIN mode is
active) to switch reader from Armed to Disarmed mode thus enabling NORMAL
users to unlock a door, alternatively they can switch reader from Disarmed to
Armed mode in order to disable unlocking of a door.
6.7.
Operation with XM-2 I/O extension module
In Full stand-alone mode the PRT32 requires connection to an external XM-2 I/O
extension module. Each input and output of the XM-2 can be programmed on the
same basis as internal inputs and outputs of a reader. The XM-2 should be
connected to the reader’s CLK and DTA lines and should have address set to ID=5.
The maximum distance between a reader and the XM-2 extension module is limited
to 150 m.
6.8.
Operation with the external PRT series reader
In Full stand-alone mode the PRT32 may optionally operate with the second PRT
series reader. In such a case the main reader is called primary reader while the
second one is called secondary reader. If used, the system with two readers
enables two-way door control. The secondary reader should be connected to the
primary reader through CLK and DTA lines and must be configured for RACS
operating mode with address ID=0. The maximum distance between primary and
secondary PRT reader is limited to 150 m.
Note: When the PRT32 reader operates with second access reader, the LED
indications on a secondary unit mimics (follows) the LEDs on primary reader.
