PRT32 v1.0 fv74.7 Rev. A EN
7/3/2009
_________________________________________________________________________________________
Page 21 of 29
[*][6][ID][PIN][#][Card] – Add single TOGGLE LTD user with an ID, PIN
and card
The new TOGGLE LTD user is registered in the memory at the location indicated by
ID number (ID=000–119). Both the entered PIN and the presented proximity card
are assigned to him. When you want to program only PIN enter:
[*][6][ID][PIN][#][#], when you want to program only card enter:
[*][6][ID][#][Card].
[7][PIN][#] – Delete a PIN
The reader searches its memory for the given PIN. Once successful it removes it
from the memory, the location previously occupied by this PIN is released. This
command removes only PIN, if the user have card he still can use it.
[8][Card] – Delete a card
The reader searches its memory for the presented card. Once successful it removes
it from the memory, the location previously occupied by this card is released. This
command removed only card , if the user have PIN he still can use it.
[9][ID] – Delete a user with entered ID
The user with entered ID is deleted (both his card and his PIN are removed), a new
user can be programmed to use this ID index.
[*][0] – Delete all users
Reader deletes all users (cards and PINs) so that all IDs are released and can be
programmed anew.
[#] – Exit User Programming mode
After exit from the User Programming mode the reader returns to the operation
mode it was in before entering it (reader returns either to Armed or Disarmed
mode).
Note: Each user ID index consists always of three digits to form ID numbers
ranging 000–119. In case you assign a new user the ID that is already occupied by
some other user, this will remove the older one from the memory.
7 . 6 . 2 .
P r o g r a m m i n g e x a m p l e s
Example 1: Add a new TOGGLE LTD user with a card - programming
sequence: [*][5][Card][#] or [*][5][Card][Wait
~
20s]
•
Read your MASTER card
•
The reader enters User Programming mode (LED OPEN is on and its LED
STATUS
is on and red)
•
Press [*]
•
Press [5]
•
LED SYSTEM starts flashing
•
Present a card which you want assign for a new user
•
Press [#]
•
Command is completed
The reader has completed programming function, however, it has not left User
Programming mode so that now you may use your next desired programming
command.
