ROBOTIQ CNC Machine Tending Kit, Инструкция по эксплуатации

Страница: 78 / 144

Robotiq CN C M achine Tending Kit Instruction M anual
4
Deviation range: the deviation range limits the flexibility allowed along/ around the corresponding axis.
a
The deviation range along the X, Y and Z axes is measured in millimeters (mm) – the negative range allowed goes from -
1000 mm to 0 mm while the positive range allowed goes from 0 mm to 1000 mm.
b
The deviation range around the X, Y and Z axes is mesured in degrees (°) – the negative range allowed goes from
-179° to 0° while the positive range allowed goes from 0° to 179°.
Example
In a situation where 10 N are applied exclusively along the Z-axis, with 20% stiffness along the X and Y axes, and a deviation
range that goes from -50 mm to +50 mm along all axes...
l
The end-effector will systematically point towards its Z-axis
l
The end-effector will not rotate around Rx, Ry and Rz (no torque feeding)
l
The end-effector will be moderately flexible to move along the X and Y axes
l
The movements along the X, Y and Z axes will be limited to -50 mm and +50 mm from the command position
Fig. 5-18: Deviation range - On the left, no deviation range has been entered. On the right, a deviation range of at least 15 degrees has
been entered around the corresponding axis.
5
Enable adaptive stiffness: this checkbox greys out the stiffness values in the boxes at step 3 since the Force Control calculates the
rigidity of the surface/ object with which the end-effector comes in contact. Thus, constant force/ torque values are applied to sur-
faces with variable rigidity (e.g.: long, bent, bending or folded sheets or parts).
When entering into contact with a surface for the first time, the end-effector will pull back for it has reached the force/ torque value
entered at steps 2a and/ or 2b. It will then go back to the surface and apply the same force/ torque values while pulling back less
and less over time.
78