Page 20 of 88
Channel Mode
The Channel Mode of the display is used to show and adjust the channel parameters of each channel
of the device.
Channel Mode is a moment ary function is accessible as long as the channel select button (SE L) be-
side the XLR connector of the respective channels is pushed.
The Channel Mode of each RockNet RN.300 device is described in detail in the respective device
section of this manual.
As soon as the SEL button is released the display goes back to default mode and shows Quad routing
and devic e ID.
The adjustment of the respective value (designation indicat ed above the res pective display) is made
by simply using one of the two buttons underneath the display.
On and OF channel parameters (like MUTE and P HANTOM) can be toggled by using either one of the
two buttons.
GAIN and CLIP LEVEL adjustments are 1dB steps with each push. Increment is done by using t he
right-hand button (+) and decrement is done by using the left-hand button (-). For speedy operation
the respective button can be held. The display stops at the end of the range or at the time of releasing
the button.
All settings are immediately active.
RN.301.MI
Left-hand di splay
MUTE
OF
OF
OF
OF
channel is not muted
On
On
On
On
channel is muted
Middle display
GAIN
-6
-6
-6
-6
…
66
66
66
66
dB
Gain in dB in 1 dB steps
factory preset
0
00
0
dB
Right-hand display
PHANTOM
OF
OF
OF
OF
+48V Phant om Power off
On
On
On
On
+48V Phant om Power on
Channel will be muted for approximately 3 seconds at Phant om Power switch (on and
off).
RN.302.LO
Left-hand di splay
MUTE
OF
OF
OF
OF
channel is not muted
On
On
On
On
channel is muted
Right-hand display
CLIP LEVEL
-9
-9
-9
-9
…
24
24
24
24
dBu
Level in 1dB steps
factory preset
24
24
24
24
dBu
RN.332. DO / RN.332. DO / RN. 333. DI
1x AES/EBU channel per XLR
Left-hand di splay
MUTE
OF
OF
OF
OF
channel is not muted
On
On
On
On
channel is muted
USO
RESTRITO
