Rhima DVS, Руководство оператора

Страница: 38 / 44

Operative Instructions
38
10.5 Alarm table
ALARM DESCRIPTION
E00 PTC PROBE BREAK First firmware installation.
E01 PTC PROBE SHORT C Chamber PT1000 / PT100 probes broken or short-circuited.
E02 NO PTC CONNECTED No PT1000 / PT100 probes has been enabled (board setting error).
E03 PTC DETECTION Mix of used probes (PT1000 / PT100).
E04 DETERGENT EMPTY Detergent liquid tank empty - nozzle probe failure.
E05 SOLVENT EMPTY Solvent liquid tank empty - nozzle probe failure.
E10 WATER NOT FILLED Mains tap is closed or the filter is dirty.
E11 LOW W. LEV. OFF Level probe malfunctioning in the water tank, faulty or disconnected.
E12 DOOR TIMEOUT Door not open or close (only for automatic door).
E13 DOOR OVERLOADING Door not open or close due to an obstacle (only for automatic door).
E14 DOOR SWITCHES. Door not lock when closing is required or not unlock when opening is requi-
red (only for manual door).
E15 MANUAL INTERRUP. Emergency button pressure where present (only for automatic door).
E16 NO WASHING Water has not dropped below the tank level probes at the end of the wa-
shing phases.
E17 S OFTENER SUPPLY The liquid tank is empty, the filter is dirty, or there is a flow meter failure, in
relation to the liquid softener.
E18 DETERGENT SUPPLY The liquid tank is empty, the filter is dirty, or there is a flow meter failure, in
relation to the liquid detergent.
E19 S OLVENT SUPPLY The liquid tank is empty, the filter is dirty, or there is a flow meter failure, in
relation to the liquid solvent.
E20 NO DISINFECTION Heating element failure, steam leaks.
E21 STEAMGEN TIMEOUT Mains tap is closed or the filter is dirty.
E22 SOL. VALVES OFF No solenoid valve enabled for washing (board setting error).
E30 SOFTENER EMPTY Softener liquid tank empty - nozzle probe failure.
E31 TEMP NOT REACHED Heating element failure, steam leaks.
E32 S T.G. HEAT: TOUT Heating element failure in the steam generator after a fixed time-out of 20
minutes.
E34 HOT WATER TEMP Washing hot water temperature is lower than the set one.
E40 STGEN OVERHEATED Overheating of the steam generator.
E41 LEAK PERIST.PUMP Liquid leak.
E42 C LOGGED SIPHON Drain pipe clogged.
E43 DOOR OPEN Door opening during a program, due to malfunction of micro-switches.
E44 CALL SERVICE Maintenance required.
E82 NTC2 PROBE BREAK Steam generator NTC probe broken or disconnected.
E83 NTC2 PROBE SHORT C Steam generator NTC probe short-circuited.
E84 C YCLE "n" INTERRUPTED Interrupted cycle due to alarm or black-out.
E85 C YCLE ABORTED After pressing the reset button while alarm E84 is displayed.
E86 MAX TEMPERATURE Chamber heating elements failure or chamber PT1000 / PT100 probe
malfunction.