Rhima DVS, Руководство оператора

Страница: 17 / 44

Operative Instructions
17
In the event of a lack of product, a message appears on
the display and the program stops.
a
WARNING! It is recommended to handle the
liquids with caution.
- Protect eyes, hands, clothes and metal surface from
contact with liquids, which contain partially irritating
agents and caustic substances.
- In case of contact with liquids, consult the instructions
provided with the product.
- Use only suitable liquids for cleaning equipment.
Carefully follow the manufacturer’s information.
- Keep chemicals out of the reach of children and
outsiders. Possibly locked away.
- Use on only the manufacturer’s approved products.
- Do not use liquids for household dishwashers.
5.4.1 Refill procedure
1) Set up a new tank with the chemical.
2) Remove the suction lance from the exhausted tank.
3) Insert the suction lance in the new tank.
Be careful not to reverse the position of the liquids.
a
WARNING! Failure to follow these
recommendations may damage the bedpan
washer.
- With regard to the maximum dosage for each
program, follow the instructions of the chemical
manufacturer.
- To ensure efficiency of the dosing system, it is
necessary to regularly carry out the maintenance
operations set out in the chapter "Maintenance".
- The indications concerning the storage and disposal
of chemical substances are provided by the respective
manufacturers and must be observed.
- Do not place the chemical containers on the machine.
Completely empty the bedpan washer before
performing maintenance and before moving the
machine to avoid contact with the chemicals and to
protect the machine components.
5.4.2 Using and storing chemicals
Keep the containers tightly closed, stored in a dry place
and protected from the sun, out of reach of children
and outsiders. Possibly locked away. Optimal storage
temperature: check the chemicals datasheet. The
shelf life in the original containers is indicated on the
chemicals’ labels. The manufacturer recommends a
method for inventory management (first in - first out).
The washer disinfector can use up to 2 products for
dosing liquids.
The manufacturer recommends using cleaning agents
and chemical additives. The use of other products can
damage the machine.
The flow meters of chemicals are calibrated according
to the density of these tested products which ensure
correct operation.
The following combinations of process fluids have been
tested to verify the compatibility of the materials with
the components inside the device. When chemical
levels are low, a warning message appears on the
display.
Chemical products dosing is set to an average value as
recommended by the manufacturer.
When the actual dosing of the chemical exceeds the
tolerance of 5%, the system goes into alarm.
a
WARNING! Use only the chemical products
recommended by the manufacturer, tested
and validated in accordance with ISO EN
15883. The use of non-certified products will
void the warranty.
The machine leaves the factory with the washing
programs set for the use of the following validated
chemical products:
Supplier: RHIMA
Detergent
Rhima Mediwash
Limescale remover*
Rhima Descale
*Optional.
a
WARNING! If the machine does not use the
liquids chosen in the machine configuration,
the flow meters must be recalibrated for the
new liquids.
a
WARNING! If the machine uses two canisters,
be careful not to swap the suction lances
when replacing the exhausted canisters:
always read the label near the canister cap
and the label on the liquid canister.
The limescale remover is calibrated to a water hardness
of up to 30°fH /16.8°DH .
6 Description of the appliance
Machine for wash and disinfection of urinals,
commodes, urology containers, kidney-shaped basins,