Rhima DVS, Руководство оператора

Страница: 16 / 44

Operative Instructions
16
- Connect the water flexible hose to connections
shown in Fig. 7.
b
HAZARD! Be careful in case of a blockage of
the drain which could cause spill out of water
and the risk of slippery floor.
1
2
Fig. 7
Water connections (Fig. 7)
12) Cold water connection.
13) Hot water connection.
a
WARNING! The flow pipes must not be
shortened or damaged.
The water supply taps must be capable of quickly
stopping the water line, therefore, they must be
equipped with a ball or a gate valve. They must also
withstand the operating pressure of the water, as
indicated in the technical data sheet.
Proper placement of the taps is shown on the Technical
Specifications (see pg. 2).
5.3 Connection of the drain trap
The machine is equipped with a built-in drain trap
which must be mandatorily connected to the drain
system of the building.
The drain pipeline can be on the floor or on the wall
according to the solution decided during purchasing.
The user must carry out periodic maintenance of the
drains and check that they are not clogged.
Before connection:
- supply the water connections with separate shut off
valves;
- flush out the water pipes that are to be connected to
the machine, to prevent clogging of filters and valves;
Procedure:
1) Connect the machine to water connections (Fig. 7).
2) Connect the bottom drain pipe to the drain
connection located at the bottom of the machine.
The correct positioning and sizing of the drain trap are
shown on the installation drawing (see the Technical
Specifications (see pg. 2)).
a
WARNING! The bedpan washer drain pipe
must be maintained if backflow and other
drainage issues are to be avoided. Be careful
not to crush the pipe. If the pipe has been
crushed, kinked, or otherwise damaged,
consider replacing it to prevent future
drainage issues.
Foreseeable misuse:
The machine should not be used:
- for disposal of materials harmful to wastewater,
e.g.:drugs, solvents, paints, etc.
- for disposal of materials such as napkins, sanitary
napkins, etc.
- for disposal of food, e.g. salad or vegetables
- for use as a toilet
5.3.1 Drain connection
The drain connection must be properly installed
according to the applicable instructions.
Bedpan washers are equipped with a Drain Control
System (D.C.S.), a safety device that stops all machine
functions if the drain trap is clogged. This prevents the
machine from being used until the breakdown situation
has been eliminated.
b
HAZARD! If the drain connection is installed
incorrectly, the drain water could flow
backwards into the machine’s chamber.
Ö
IMPORTANT NOTE! The manufacturer is not
liable in case of environmental pollution due
to an incorrect use of the bedpan washer.
5.4 Chemicals
The bedpan washer adopts as standard 1 pump for
limescale remover. On request it can have up to a
maximum of 2 dosing pumps for:
- Detergent agent;
- Limescale remover.
Each dosing pump is monitored by a flowmeter.
This electronic control checks the dosing amount.