Rhima DVS, Руководство оператора

Страница: 13 / 44

Operative Instructions
13
If the machine is to be moved, it is advisable to keep the
packaging for any other relocation.
If this is not provided, dispose of the packaging
materials: cardboard, polystyrene and other, separated
by single material, sending them to the most
appropriate final destination, which may be recovery or
storage in landfills.
4.I Storage
If the packaged machine is temporarily stored, make
sure that it is not subjected to blows and tampering.
However, it must be placed in a closed, dry, dust-free
environment and protected from atmospheric agents.
When restored, a careful preliminary examination of its
integrity by specialised personnel is necessary.
Absolutely avoid overlapping weights or foreign bodies
on the packaging and the machine.
5 Installation
It is advisable that only furniture for professional use
be positioned in the area around the machine, to avoid
ruining them due to possible leakage of condensation
water.
Ö
IMPORTANT NOTE! For a safe installation,
the electrical disconnector/plug of the device
must be positioned free from any obstacle
and in a visible and accessible position for
the operator, so that it's easy to control
it in case of emergency or prolonged safe
disconnection.
b
HAZARD! Do not install and/or use the
bedpan washer in environments with
flammable/explosive atmosphere.
a
WARNING! Make sure that the floor, or
the wall, is fit to support the load of the
equipment when in operation, equal to 120
Kg /265 lb minimum.
a
WARNING! Make sure that the machine is
perfectly vertical and stable, using a spirit
level, if necessary.
Unevenness of the machine surface and height can
be adjusted with the adjustable feet placed under the
machine itself (when available).
b
HAZARD! All electrical and water connections
(loading/unloading) can only be carried out
by specialised and authorised personnel and
by consulting the relative diagrams.
Before machine positioning make sure that:
- All the components needed for installation and proper
use of the machine were installed: main switch, water
supply taps, drain and anything else needed.
- These components should have all the needed
features and should be installed at the locations
shown in the installation scheme.
a
WARNING! The use of unsuitable parts,
and/or the implementation of installation
procedures other than those shown in the
Technical Specifications (see pg. 2), will
immediately void the machine warranty.
- The characteristics of the electricity network must
be compatible with the values required for correct
operation indicated on the machine identification
plate and on the technical data sheet.
- The machine must be connected to an efficient
earthing system (according to electrical safety
standards).
Ö
IMPORTANT NOTE! The manufacturer is not
to be held liable for any damage caused by
improper grounding of the machine or faulty
power supply.
5.1 Electrical connection
c
HAZARD! Only qualified and experienced
personnel can connect the machine to the
mains supply, in compliance with the current
laws and regulations.
a
WARNING! In the single-phase version, the
main switch of the power supply line must be
a multi-pole circuit breaker, with adequate
residual current protection.
a
WARNING! In the three-phase version,
the main switch must be multi-pole circuit
breaker, with adequate residual current
protection, positioned near the machine and
not covered by machines or other that may
hinder its use.