Installation
Operating_Manual_Fan_KXE_04_en.docx
36 / 128
If the fan has been delivered in several sections for reasons
of transport, please refer to the chapters specified below:
- Chapter 7.3.1 Procedure
- Chapter 7.3.2 Screw connections
If the rotor has been delivered in a transport fixture, this
transport fixture must also be retained for subsequent
commissioning work and return deliveries.
The assembly site must meet the following requirements:
- Affords ample room
- Level, clean-swept and free of oil
- Affords stability
- Capable of supporting the weight of the fan and its
accessories
- Equipped with suitable lifting devices or accessible for
floor conveyor vehicles (e.g. forklift truck)
NOTICE!
Refer to the weight specifications and the dimensions
in the separate general drawing of the fan.
If several fans of the same structural design are delivered
together, the following components are clearly identified with
a six-digit serial number (e.g. 300851):
- Housing lower sections
- Housing upper sections
- Rotors (impeller shaft bearing units)
- Other accessory parts
Only components featuring the same serial number may be
assembled with one another.
7.3 Assembling the fan
Fig. 7-1 Spatial requirement at the
assembly site (fan shown as
an example)
