RAM CHASSIS CAB 2024, Руководство пользователя

Страница: 162 / 360

NOTE:
Check the automatic transmission fluid level before
towing (6-speed automatic only).
Tow/Haul Mode
To reduce potential for automatic transmission over-
heating, activate TOW/HAUL mode when driving in hilly
areas, or select a lower gear range (using the Electronic
Range Select (ERS) shift control) on more severe
grades.
Cruise Control — If Equipped
•
Do not use on hilly terrain or with heavy loads.
•
When using the Cruise Control, if you experience
speed drops greater than 10 mph (16 km/h), disen-
gage until you can get back to cruising speed.
•
Use Cruise Control in flat terrain and with light loads
to maximize fuel efficiency.
SNOWPLOW — IF EQUIPPED
Snowplow Prep Packages are available as a factory
installed option. These packages include components
necessary to equip your vehicle with a snowplow.
NOTE:
Before installation of a snowplow it is highly recom-
mended that the owner/installer obtain and follow the
recommendations contained within the current Body
Builder’s Guide. See an authorized dealer, installer or
snowplow manufacturer for this information. There are
unique electrical systems that must be connected to
properly ensure operator safety and prevent overload-
ing vehicle systems.
WARNING!
Attaching a snowplow to this vehicle could adversely
affect performance of the airbag system in a collision.
Do not expect that the airbag will perform as
described earlier in this manual.
CAUTION!
The “Lamp Out” indicator could illuminate if exterior
lamps are not properly installed.
BEFORE PLOWING
•
Check the hydraulic system for leaks and proper
fluid level.
•
Check the mounting bolts and nuts for proper
tightness.
•
Check the runners and cutting edge for excessive wear.
The cutting edge should be ¼ to ½ inches (6 cm to
1.2 cm) above ground in snow plowing position.
•
Check that snowplow lighting is connected and func-
tioning properly.
SNOWPLOW PREP PACKAGE
MODEL AVAILABILITY
For Information about snowplow applications visit
www.ramtrucks.com or refer to the current Body Build-
er’s Guide.
1. The maximum number of occupants in the truck
should not exceed two.
2. The total GVWR or the Front GAWR or the Rear
GAWR should never be exceeded.
3. Cargo capacity will be reduced by the addition of
options or passengers, etc.
The loaded vehicle weight, including the snowplow sys-
tem, all aftermarket accessories, driver, passengers,
options, and cargo, must not exceed either the Gross
Vehicle Weight Rating (GVWR) or Gross Axle Weight Rat-
ing (GAWR). These weights are specified on the Safety
Compliance Certification Label on the driver's side door
opening.
NOTE:
Detach the snowplow when transporting passengers.
Vehicle front end wheel alignment was set to specifica-
tions at the factory without consideration for the weight
of the plow. Front end toe-in should be checked and
reset if necessary at the beginning and end of the
snowplow season. This will help prevent uneven tire
wear.
The blade should be lowered whenever the vehicle is
parked.
Maintain and operate your vehicle and snowplow equip-
ment following the recommendations provided by the
specific snowplow manufacturer.
OVER THE ROAD OPERATION WITH
SNOWPLOW ATTACHED
The blade restricts air flow to the radiator and causes the
engine to operate at higher than normal temperatures.
Therefore, when transporting the plow, angle the blade
completely and position it as low as road or surface condi-
tions permit. Do not exceed 40 mph (64 km/h). The
operator should always maintain a safe stopping distance
and allow adequate passing clearance.
160 STARTING AND OPERATING