RAM CHASSIS CAB 2024, Руководство пользователя

Страница: 141 / 360

•
When the LaneSense system senses the lane has been
approached and is in a lane departure situation, the
left lane line flashes yellow (on/off). The LaneSense
telltale
changes from solid yellow to flashing yel-
low. At this time torque is applied to the steering wheel
in the opposite direction of the lane boundary.
For example: If approaching the left side of the lane
the steering wheel will turn to the right.
NOTE:
The LaneSense system operates with similar behavior
for a right lane departure.
CHANGING LANESENSE STATUS
The LaneSense system has settings to adjust the inten-
sity (Low/Medium/High) of the torque warning and the
warning zone sensitivity (Early/Medium/Late) that you
can configure through the Uconnect system
page 165.
NOTE:
•
When enabled the system operates above 37 mph
(60 km/h) and below 112 mph (180 km/h).
•
Use of the turn signal suppresses the warnings.
•
The system will not apply torque to the steering
wheel whenever a safety system engages (Anti-Lock
Brakes, Traction Control System, Electronic Stability
Control, Forward Collision Warning, etc.).
TURN SIGNAL ACTIVATED BLIND
SPOT ASSIST — IF EQUIPPED
When enabled in the Uconnect system and a turn signal
is activated, the corresponding side view mirror camera
will display in the radio. The camera will continue to
display as long as the turn signal is engaged. If “Only
With Trailer” is selected (if equipped), the camera will
only display when a trailer is connected to the vehicle
page 165.
WARNING!
Blind Spot Assist is only an aid to help detect objects
in the blind spot zones and may not provide alerts
when changing lanes under all driving conditions.
Even if your vehicle is equipped with the BSA system,
always check your vehicle's mirrors, glance over your
shoulder, and use turn signals before changing lanes.
Failure to do so can result in serious injury or death.
PARKVIEW REAR BACK UP CAMERA
The ParkView Rear Back Up Camera allows you to see
an on-screen image of the rear surroundings of your
vehicle whenever the gear selector is put into REVERSE.
The image will be displayed on the Uconnect display
along with a caution note to “Check Entire Surround-
ings” across the top of the screen. After five seconds
this note will disappear. The ParkView Camera is
located in the center of the tailgate handle.
NOTE:
For the 3500, 4500, and 5500 Chassis Cab vehicles,
the Rear Back Up Camera is shipped loose and not
installed. Please refer to the Ram Body Builder’s Guide
for more information.
Manual Activation Of The Rear View
Camera:
1. Press the Controls button located on the bottom of
the Uconnect display.
2. Press the Back Up Camera icon to turn the Rear
View Camera system on.
When the vehicle is shifted out of REVERSE with cam-
era delay turned off, the rear camera mode is exited
and the previous screen appears. When the vehicle is
shifted out of REVERSE with camera delay turned on,
the camera image will continue to be displayed for up
to 10 seconds unless the following conditions occur:
The vehicle speed exceeds 8 mph (13 km/h), the
vehicle is shifted into PARK, the vehicle’s ignition is
placed in the OFF position, or the user presses the
touchscreen X button to exit out of the camera video
display.
Lane Crossed (Flashing Yellow Lane Line) With Flashing
Yellow Telltale
STARTING AND OPERATING 139
4