RAM CHASSIS CAB 2024, Руководство пользователя

Страница: 23 / 360

REMOTE START — IF EQUIPPED (DIESEL)
This system uses the key fob to start the
engine conveniently from outside the vehicle
while still maintaining security. The system has
a range of approximately 328 ft (100 m).
Remote Start is used to defrost windows in cold
weather, and to reach a comfortable climate in all ambi-
ent conditions before the driver enters the vehicle.
NOTE:
•
Obstructions between the vehicle and the key fob
may reduce this range.
•
The Remote Start system will wait for the Wait To
Start Light
page 93 to extinguish before crank-
ing the engine. This allows time for the intake heater
to preheat the incoming air, and is normal operation
in cold weather
page 346.
HOW TO USE REMOTE START
Push and release the Remote Start button on the key fob
twice within five seconds. The vehicle doors will lock, the
parking lights will flash, and the horn will chirp twice (if pro-
grammed). Then, the engine will start, and the vehicle will
remain in the Remote Start mode for a 15 minute cycle.
Pushing the Remote Start button a third time shuts the
engine off.
To drive the vehicle, push the unlock button, and place
the ignition in the ON/RUN position.
All of the following conditions must be met before the
engine will remote start:
•
Gear selector in PARK
•
Doors closed
•
Hood closed
•
Hazard switch off
•
Brake switch inactive (brake pedal not pressed)
•
Battery at an acceptable charge level
•
Panic button not pushed
•
Fuel meets minimum requirement
•
Water In Fuel Indicator Light is not illuminated
•
Wait To Start Light is not illuminated
•
Malfunction Indicator Light (MIL) is not illuminated
For additional functions of the Remote Start system,
see
page 20.
WARNING!
•
Do not start or run an engine in a closed garage or
confined area. Exhaust gas contains carbon mon-
oxide which is odorless and colorless. Carbon mon-
oxide is poisonous and can cause serious injury or
death when inhaled.
•
Keep key fobs away from children. Operation of the
Remote Start system, windows, door locks or other
controls could cause serious injury or death.
VEHICLE SECURITY SYSTEM —
IF EQUIPPED
The Vehicle Security system monitors the vehicle doors
and ignition for unauthorized operation. When the
Vehicle Security system is activated, interior switches
for door locks are disabled. If something triggers the
alarm, the Vehicle Security system will provide the fol-
lowing audible and visible signals:
•
The horn will pulse
•
The turn signals will flash
•
The Vehicle Security Light in the instrument cluster
will flash
TO ARM THE SYSTEM
Follow these steps to arm the Vehicle Security system:
1. Make sure the vehicle’s ignition is placed in the OFF
position.
○
For vehicles equipped with Keyless Entry, make
sure the vehicle’s keyless ignition system is OFF.
2. Perform one of the following methods to lock the
vehicle:
○
Push the lock button on the interior power door
lock switch with the driver and/or passenger
door open.
○
Push the lock button on the exterior Passive
Entry door handle with a valid key fob available
in the same exterior zone
page 23.
○
Push the lock button on the key fob.
3. If any doors are open, close them.
The Vehicle Security system will set when you use the
power door locks, or use the key fob to lock the doors.
After all the doors are locked and closed, the Vehicle
Security Light, in the instrument panel cluster, will flash
rapidly for about 16 seconds to indicate that the alarm
is being set. After the alarm is set, the Vehicle Security
Light will flash at a slower rate to indicate that the sys-
tem is armed.
GETTING TO KNOW YOUR VEHICLE 21
2