RAM CHASSIS CAB 2024, Руководство пользователя, Страница: 135 / 360

STATIONARY OBJECTS AND VEHICLES
ACC does not react to stationary objects or vehicles. For
example, ACC will not react in situations where the
vehicle you are following exits your lane and the vehicle
ahead is stopped in your lane. It will consider this
stopped vehicle a stationary object as it did not previ-
ously detect movement from it. Always be attentive and
ready to apply the brakes if necessary.
PARKSENSE FRONT/REAR PARK ASSIST —
IF EQUIPPED
The ParkSense Park Assist system provides visual and
audible indications of the distance between the rear,
and/or front fascia/bumper, and a detected obstacle
when backing up or moving forward (e.g. during a park-
ing maneuver). For limitations of this system and rec-
ommendations, see
page 136.
ParkSense will retain the system state (enabled or dis-
abled) from the previous ignition cycle when the ignition
is placed in the ON/RUN position.
ParkSense can be active only when the gear selector is
in REVERSE or DRIVE. If ParkSense is enabled at one of
these gear selector positions, the system will remain
active until the vehicle speed is increased to approxi-
mately 7 mph (11 km/h) or above. A warning will
appear in the instrument cluster display when the
vehicle is in REVERSE, indicating the vehicle is above
ParkSense operating speed. The system will become
active again if the vehicle speed is decreased to less
than approximately 6 mph (9 km/h).
PARKSENSE SENSORS
For the 3500, 4500 and 5500 Chassis Cab vehicles,
the rear ParkSense sensors are shipped loose. Please
refer to the Ram Body Builder’s Guide for more
information.
The four ParkSense sensors are to be located in the
rear fascia/bumper, and monitor the area behind the
vehicle that is within the sensors’ field of view.
The sensors can detect obstacles from approximately
12 inches (30 cm) up to 79 inches (200 cm) from the
rear fascia/bumper in the horizontal direction, depend-
ing on the location, type and orientation of the obstacle.
NOTE:
If equipped as a dually, the ParkSense system has six
rear sensors to assist detection around the dually
flares.
The six ParkSense sensors, located in the front fascia/
bumper, monitor the area in front of the vehicle that is
within the sensors’ field of view. The sensors can detect
obstacles from approximately 12 inches (30 cm) up to
47 inches (120 cm) from the front fascia/bumper in the
horizontal direction, depending on the location, type
and orientation of the obstacle.
PARKSENSE WARNING DISPLAY
The ParkSense Warning screen is located within the
instrument cluster display
page 78. It provides
visual warnings to indicate the distance between the
rear fascia/bumper and/or front fascia/bumper and
the detected obstacle.
PARKSENSE DISPLAY
The warning display will turn on indicating the system
status when the vehicle is in REVERSE or when the
vehicle is in DRIVE and an obstacle has been detected.
The system will indicate a detected obstacle by showing
a single arc in the left and/or right rear regions based
on the obstacle’s distance and location relative to the
vehicle.
Narrow Vehicle Example
Stationary Object And Stationary Vehicle Example
STARTING AND OPERATING 133
4