Keyless Push Button Ignition
1 — OFF
2 — ON/RUN
The push button ignition can be placed in the following
modes:
OFF
●
The engine is stopped
●
Some electrical devices (e.g. power locks, alarm,
etc.) are still available
ON/RUN
●
Driving position
●
All electrical devices are available (e.g. climate
controls, heated seats, etc.)
START
●
The engine will start (when foot is on the brake)
NOTE:
If the ignition switch does not change the mode by
pushing the button, the key fob may have a low or
depleted battery. In this situation, a backup method can
be used to operate the ignition switch. Put the nose
side (side opposite of the emergency key) of the key
fob against the START/STOP ignition button and push to
operate the ignition switch.
Backup Starting Method
WARNING!
●
When exiting the vehicle, always remove the key
fob from the vehicle and lock your vehicle.
●
Never leave children alone in a vehicle, or with
access to an unlocked vehicle.
●
Allowing children to be in a vehicle unattended
is dangerous for a number of reasons. A child
or others could be seriously or fatally injured.
Children should be warned not to touch the
parking brake, brake pedal or the gear selector.
(Continued)
WARNING!
●
Do not leave the key fob in or near the vehicle,
or in a location accessible to children, and do
not leave the Keyless Enter ‘n Go™ Ignition in
the ON/RUN position. A child could operate power
windows, other controls, or move the vehicle.
●
Do not leave children or animals inside parked
vehicles in hot weather. Interior heat buildup may
cause serious injury or death.
CAUTION!
An unlocked vehicle is an invitation for thieves.
Always remove key fob from the vehicle and lock all
doors when leaving the vehicle unattended.
NOTE:
●
The key fob may not be detected by the vehicle
Keyless Enter ‘n Go™ system if it is located next to
a mobile phone, laptop or other electronic device;
these devices may block the key fob’s wireless signal
and prevent the Keyless Enter ‘n Go™ system from
starting the vehicle.
●
For more information on normal engine starting, see
.
●
When opening the driver's door and the ignition is in
the ON/RUN position (engine not running), a chime
will sound to remind you to place the ignition in the
OFF position. In addition to the chime, the message
“Ignition ON” will display in the cluster.
GETTING TO KNOW YOUR VEHICLE 21
2
