Choose Exit Method — Parallel Parking
The exit method options for perpendicular parking are
Reverse Left and Reverse Right.
Choose Exit Method — Perpendicular Parking
NOTE:
If an exit method selection is attempted before the
vehicle is stopped, the driver will be instructed to stop
the vehicle to make a selection.
After the driver chooses a parallel exit side, a message
appears in the Uconnect display with instructions to
hold the brake pedal and hold down the Active Park
Assist switch. Both of these conditions must be met
before the maneuver can begin.
When the Active Park Assist switch is held down,
the turn signal for the chosen exit side will turn on
automatically.
The system will then instruct the driver to remove hands
from the steering wheel and feet from the pedals. This
screen will be shown for a minimum of two seconds, or
until the driver releases the brake pedal.
When the exit sequence is initiated by the driver
after the previously described conditions are met, the
Uconnect system will display a Top View along with
either a rear camera view (if the vehicle is placed in
REVERSE) or a forward camera view (if the vehicle is
placed in DRIVE), and the exit maneuver will begin.
The Top View will have integrated ParkSense arcs in the
image at the front and rear of the vehicle. The arcs
will change color from yellow to red corresponding the
distance zones to the oncoming object.
The automatic maneuver ends when the vehicle is
clear of the parking space, and the display shows the
message of a completed maneuver. The vehicle will be
in DRIVE and held hydraulically by the brakes until the
driver presses the accelerator pedal. The system gives
vehicle control back to the driver.
Once the driver regains control of the vehicle, a chime
will sound and the LED on the switch will turn off.
After approximately five seconds, the previous Uconnect
screen will display.
162 STARTING AND OPERATING
Parking Maneuver Paused/Canceled
Certain conditions can pause or cancel a Fully
Automated park or exit maneuver.
The ParkSense Automated Parking system can be
paused due to the driver’s finger being removed from
the Active Park Assist switch and/or an object in the
vehicle’s path during a parking maneuver.
If one or more of these scenarios occur, automatic
braking will bring the vehicle to a stop and hold the
vehicle hydraulically by the brakes.
The driver will be instructed to hold the Active Park
Assist switch to continue the park or exit maneuver. If
the driver does not resume holding the switch down,
the maneuver will cancel.
If the maneuver is paused due to an object in the
vehicle’s path, a message will appear in the Uconnect
display. The maneuver will remain paused until the
object is no longer in the vehicle’s path.
The system can also be paused before the Active Park
Assist switch is held down if the driver shifts into
REVERSE.
The driver will be instructed to shift to DRIVE to
continue the maneuver. If the vehicle is shifted into
DRIVE, the process will continue on to the seek/
maneuver selection phase.
