Racepak Ultra Dash Xtreme, Инструкция по установке и эксплуатации

Страница: 32 / 41

Programming Using the DataLink PC Software
28
Adding or Removing V-Net Devices to your System
If you add or remove modules from you system, you will need to update your configuration file to match
the configuration of your onboard system. If the changes are permanent you should edit your existing
configuration file to match the new setup.
To update the configuration file load the appropriate configuration file by using the
Open Car
Configuration File menu selection located in the File main menu selection. Make sure the configuration
file is the active file by positioning the mouse cursor over the file tab for the file and click the left mouse
button.
Connect your PC to the dash using the serial communication cable and power up your system. Next select
the
Read VNet Config selection located in the Edit main menu selection. The DataLink software will now
query the V-Net modules in your system and will read in the current configuration of the system. During
this process a message log dialog box will be displayed. The progress of the read will be displayed in the
message log box.
If a V-Net module that is included in the current configuration file is not found in the System, the following
message will be displayed.
If you have removed the module from the system you should select
Yes to remove the module from the
configuration file. If you have not removed the module from the system you should select No and then
inspect your system to be sure the module is properly installed. When you have corrected the problem you
should repeat the process above.