Racepak Ultra Dash Xtreme, Инструкция по установке и эксплуатации

Страница: 20 / 41

Programming and Operation Using the Dash Buttons
16
Real-time Mode
The dash will power up in Real-time mode each time it is turned on. While in Real-time mode you can
scroll between the three main display pages by entering a SHORT key press on the button. To change
the lower right display enter a SHORT press on the button.
Table 4 shows the channel positions for each of the three display pages. These are the factory defaults.
They can be changed using the DataLink PC software
.
LCD Section Channel Displayed
Swept Tach Engine RPM
Middle Center Speedometer
Upper Left Fuel Level
Lower Left Water Temperature
Lower Center Maximum Exhaust Gas Temperature Value and Cylinder Number
DISPLAY #1
Lower Right Odometer/ Trip / EGT 3 / EGT 4
(see note below)
Swept Tach Speedometer
Middle Center Engine RPM
Upper Left Ace Setting
Lower Left Water Temperature
Lower Center Maximum EGT Value and Cylinder Number
DISPLAY #2
Lower Right Odometer/ Trip / EGT 3 / EGT 4
(see note below)
Swept Tach Engine RPM
Middle Center Speedometer
Upper Left Water Temperature
Lower Left EGT 1
Lower Center EGT 2
DISPLAY #3
Lower Right Odometer/ Trip / EGT 3 / EGT 4
(see note below)
Table 4
Note:
The number 4 will not show in the channel tag when EGT four is displayed in the lower right corner.
Only the tag EGT will display for channel four.