Racepak Ultra Dash Xtreme, Инструкция по установке и эксплуатации

Страница: 12 / 41

Ultra Dash Installation
8
Remote Switch
The remote switch is used to change dash displays and start recording data without the rider having to
remove their hand from the bars. The remote switch also used to record data for playback. If you do not
wish to use these functions you may leave the remote switch uninstalled if desired.
ACTION FUNCTION
Press and release button Scroll between the three display pages
Press and hold button until the word REC
appears below the swept tach.
Dash will begin recording. (See Recoding Mode )
External Battery
An external Ni-Cad battery can be used to power the dash when the engine is not running and power is not
available to the main power input at port A pin 13. When the engine is shut off or the main power is
disconnected the dash will remain powered on the external battery until the max. on time has expired
without any button presses. (see Setup mode MXON). To turn the dash on without main power, press and
hold the button until the dash completely turns on. See Port B Wiring for information on wiring an
external battery.
WARNING!!
While the engine is running the dash will slowly charge the external battery. Make sure to only
use a 9–18 volt Ni-Cad battery. Attempting to use and charge other types of batteries could
cause them to leak and/or explode.