Racepak Ultra Dash Xtreme, Инструкция по установке и эксплуатации

Страница: 31 / 41

Programming Using the DataLink PC Software
27
The option edit box will display an appropriate edit box for the option currently selected in the options list.
The edit box will display the name of the option being edited, the current value of the option, and the range
of values that can be entered for the option is appropriate. Enter the new value for the option here
After you have read the online help and have modified the setup parameters as desired, the next step is to
send the new setup from the PC to the actual device being programmed. Be sure the dash is connected to
your PC using the serial interface cable. Next apply power to your data logger system and wait for
approximately 5 seconds for your system to enter normal operation. Next select the
SEND Configuration
button in the channel edit dialog box to send the information to the device being programmed. A progress
box will be displayed to indicate whether the transfer is successful.
After you have successfully sent the new information to the device being programmed you should see the
message Device Programmed Successfully at the bottom of the massage log. Select the
OK button to exit
the dialog box. As a final step save the car configuration file to your disk by clicking on the save icon in
the DataLink Toolbar or select the Save menu item located in the Files main menu selection.
You have completed the programming of the device/channel. Repeat the above process for each of the
devices you wish to modify.
Changing Dash Display Page Properties
The channel buttons labeled “Dash Page #1”, “Dash Page #2”, “Dash Page #3”, “Dash Page #4” represent
the four LCD display pages that change when you press the or button on the dash. If you
would like to change the variables displayed on a display page or change the characteristics of the
displayed value perform the following.
1) Right click over the channel button of the display page you wish to change.
2) Review the instructions in the upper left dialog box.
3) Locate the graphic representation of the dash to the left of the help box and click on the button of
the display to be modified.
4) Enter the desired parameters.
5) Click OK to accept the changes.
6) Repeat for all displays to be modified.
7) When you are finished editing each display page, click on the
SEND Configuration button in the
lower right corner.