Racepak Ultra Dash Xtreme, Инструкция по установке и эксплуатации, Страница: 29 / 41

Programming Using the DataLink PC Software
25
The next step is to read the current setting from the dash. To do this, connect the supplied serial cable
between the dash and your PC and turn on the dash. Next, Start the DataLink software and click on
Edit
from the menu bar and select Read VNET Config . A status message box will appear, if everything is
working correctly you see the message “Devices Read Successfully” when finished.
The wrench icon in the run file tab is used to indicate that this file is a car configuration file. Each of the
buttons represents one of the devices/channels in your system. For instance the VDash Module button
represents your Ultra Dash, the Engine Rpm button represents the engine rpm channel,
After you have opened the car configuration file the next step in modifying the setup of your system is to
select the device/channel to be modified. To select a device/channel position the mouse cursor over the
desired button, for instance VDash Module in our sample, and click the right mouse button. An edit dialog
box, as shown below , will open to allow you to edit the parameters for that specific device/channel.
In addition to allowing you to edit the device/channels parameters the dialog box also contains online help
to instruct you on the procedure for configuring the device and the options available for each of the
parameters that can be modified. Although each of the dialog boxes for the different devices are slightly
different, all of the dialog boxes have the same overall structure.
Channel
description
Channel
scaling
Online Graph
Help setup
Options
Channel edit box
options
Options
help box