Racepak Ultra Dash Xtreme, Инструкция по установке и эксплуатации

Страница: 13 / 41

Ultra Dash Installation
9
Installing V-Net Channels
You can add up to five additional channels to your Ultra Dash by installing modules on the V-Net port. For
instance, if you wanted to monitor turbo boost pressure you would need to purchase a boost pressure V-Net
module. Follow the steps below to add V-Net modules to your Ultra Dash.
Step #1 — Unplug the factory installed terminator cap from the V-Net port on the back of the dash
Step #2 — Plug the V-Net extension cable in the V-Net port.
Step #3 — Plug the other end of the V-Net cable in to the first V-Net module. You can install up to five V-
Net modules. You can plug the V-Net modules in any order that is convenient. The modules can be
plugged directly in to each other or a V-Net extension cable can be used between modules if necessary.
Step #4 — Plug the terminator cap removed in step #1 in to the last V-Net module.
Module
& Sensor
Terminator
Cap
Ultra Dash
V-Net Port
Module
& Sensor
IMPORTANT!!
Do not use two modules with the same V-Net ID.
The V-Net ID can be found on the front page of
the documentation included with each V-Net
module.