Racepak Ultra Dash Xtreme, Инструкция по установке и эксплуатации

Страница: 23 / 41

Programming and Operation Using the Dash Buttons
19
Min – Max Recall Mode
The min – max recall mode displays the minimum and maximum reading on all channels since the dash
was turned on or the min – max values have been manually cleared. The dash does not need to be in
Record mode for the min-max values to update. To display the minimum values enter a SHORT press on
the button. The word
MIN
will be displayed under the swept tach. To display the maximum values
enter a SHORT press again on the button. The word
MAX
will be displayed under the swept tach.
While you are in min – max mode you may change displays or enter in to scroll mode to see additional
channels if needed. To return to Real-time mode and exit min – max mode, again enter a SHORT press on
the button. The work
PLAY
will appear. This puts you in Playback mode which we will discuss in
the next section. Again enter a SHORT press on the button to return to Real-time mode.
To clear the minimum and maximum values enter a LONG press on the button in any mode except
Setup mode.
Record Mode
The Ultra Dash has up to10 minutes of record time. While in record mode all channels except the warning
indicators will be recorded. After a recording you may playback the data on the dash or download it to our
optional DataLink PC software. Recorded data will remain in memory, even if the dash is turned off, for
up to 2 days or until a new recording has been made. To enter Record Mode, press and hold the remote
switch button until the word
REC
is displayed below the swept tach position. To exit Record, mode enter
three consecutive SHORT button presses on the button.
Playback Mode
Playback mode allows you to playback recorded data on the dash. To enter Playback mode, enter a
SHORT press on the button while in Real-time mode. This will put you in Min mode. Enter a second
SHORT press on the button to enter Max mode. Enter a third SHORT press on the button to
enter Playback mode. The word
PLAY
will display under the swept tach to indicate you are in Playback
mode. Once in Playback mode use the and buttons to move forward and backward in time
according to the table below.
Table 8 shows the behavior of each button while in Playback mode.
Button
SHORT Button Press
(one light flash)
MED Button Press
(two light flashes) LONG Button Press
(three light flashes)
Exit Playback Mode Enter setup mode
Reset minimum & maximum
recall values
Change display pages Does nothing Turn the back light on or off
Enter scroll mode Does nothing Does nothing