Racepak Ultra Dash Xtreme, Инструкция по установке и эксплуатации

Страница: 11 / 41

Ultra Dash Installation
7
Pin 10 – External Warning Light Output – Connect this wire only if you plan to use an external warning
light. Insert the orange/white wire in pin position 10. Connect the other end of the orange/white wire to
the ground side of your warning light. Connect the other side of the warning light to power.
Pin 11 – EGT #4 Probe Positive – Insert the yellow wire from EGT #4 probe in pin position 11.
Pin 12 – EGT #4 Probe Negative – Insert the red wire from EGT #4 probe in pin position 12.
Sensor Installation
EGT Probe Installation
Instructions for the installing the EGT probes in the pipe are provided in the EGT probe package. Follow
the instructions provided in the package.
Water Temperature Sensor Installation
The water temperature sensor is typically installed in place of the OEM temperature switch. The water
temperature sensor provided uses 1/8” NPT thread. An adaptor will be required if your current temperature
switch uses a larger thread. Make sure to use thread sealer when installing the sensor to prevent water
leaks.
Removing Wires from the Connector and/or changing EGT Probes
Removing a wire from the connector or changing an EGT probe requires a special tool which can be
purchased from your dealer. Carefully follow the instructions provided with the tool if you need to remove
a pin from the connector.
Jack Shaft Sensor and Collar Installation
Due to the various jack shaft diameters the collar which holds the magnet must be purchased separately. If
you did not purchase a jack shaft collar contact your dealer for more information.
Install the collar on the jack shaft. Make sure the collar fits snug and cannot slip. If the collar does not fit
properly contact your dealer to obtain a correctly sized collar. Mount the sensor so that it is directly over
the collar and has 0.050” to 0.075” air gap. Connect the purple wire from the dash port A pin 12 to the red
connector on the sensor. Connect the sensors black wire to chassis ground.
Jack Shaft Collar