QSI QS-2plus!, Руководство пользователя

Страница: 74 / 140

u
Section 6 RESET Feature Guide 74
2. Setting Diesel Motor Threshold
If you apply power and notice your diesel engine moving before the motor starts
to rev up, you can adjust the threshold for the motor. Real diesel engines
usually rev up before the engine actually moves. If your transformer goes to a
very low voltage, so the engine is on but not moving, you can set the threshold
to begin before the engine moves. Or you can set the threshold right at the stall
point.
Note: There is no setting for motor rev. rate, like there is for chuff rate. Motor
revs will increase at the same rate as the throttle goes up, regardless of the
threshold setting.
T o S e t t h e M o t o r T h r e s h o l d
••
Find RESET Position #27
••
Press and release the Horn Button
You will hear a "ding" and your engine
will start to move out in forward.
Lower throttle until engine stops, or a few notches below
••
Reduce voltage to the point where you want the engine to start to rev
up (this may be a few notches lower than the voltage at which the
engine actually stalls)
You will not hear the usual "rumbling" motor sounds.
••
Press and release the Horn Button again
You will hear two "dings". You have set the throttle setting or track voltage
where the diesel "rumble" sounds will begin. Your engine will still be in
forward.
Press the horn button to set the diesel motor threshold
ding, ding
ding