- 9 -
1500_GB-ANBAU_2719
ATTACHING
GB
Hydraulic connection
Connect hydraulic line to tractor
- Switch off pto before attaching
- Set tractor's control unit lever at "Neutral"
- Connect hydraulic line
Make certain that the hydraulic line is connected to the
tractor only with the stopcock closed (pos. A)
Couple the plug-in connector marked {EW to the single-
acting control valve.
Electro-connection
Lighting:
- Attach 7-pin plug to tractor (E3)
- Check that the machine's lighting functions.
Rope
- Lay the rope (S) into the tractor cabin
Fit cardan shaft
- Switch off engine and remove ignition key.
- Before fitting the cardan shaft, clean and grease the
machine's connection profiles and the pto.
- First install the wide-angle joint to the machine.
- Then attach the cardan shaft to the tractor's pto.
- Secure the guard tubes for all cardan shafts against
rotating by attaching the safety chains.
Be advised!
Check the cardan shaft length prior to
initial operation and adjust if necessary
The cardan shaft is adapted specifically
to each tractor!
Cutting to length procedure
- To adapt the lengths, hold cardan shaft halves next
to one another in the shortest operating position (L2)
and mark.
Shortest possible operating position (L2):
1. Lifting gear completely down
2. Steering turned to lock.
(see adjacent figure)
354-15-41
L2
For details see Chapter "Adjusting the cardan shaft" in
Supplement B of these Operating Instructions.
Lower the machine
• Lower machine to the working height of "75 cm" using
the tractor's hydraulics (see sketch).
TD 28/94/10
75 cm
