98
En
Additional Information
13
Problem
General
Recorder won’t switch on
The disc is automatically ejected after
closing the disc tray
No picture
Can’t play a disc
Settings have disappeared
Screen goes blank and operation
buttons don’t work
mark appears on screen
mark appears on screen
Remote control does not work
No sound or sound is distorted
The picture from the external input is
distorted
Remedy
•
Make sure the recorder is plugged in (
page 15
)
•
Check that the disc is loaded properly (aligned in disc tray and label-side up)
•
Take out the disc and clean it (
page 95
)
•
Check that the disc has a region code compatible with the recorder (
page 10
)
•
Check that everything is connected properly (
chapter 2
)
•
Check that the connected TV and/or the AV receiver is set to the correct input
•
Check that the disc is NTSC
•
The recorder may be set to Progressive-scan with an incompatible TV. Reset to
Interlace by pressing and holding
8
PAUSE
(front panel) then pressing
FL DIMMER
.
•
Take out the disc and clean it (
page 95
)
•
Check that the disc is loaded properly (aligned in disc tray and label-side up)
•
Check that the disc has a region code compatible with the recorder (
page 10
)
•
There may be condensation in the player. Leave the recorder for an hour or so.
•
If the recorder is unplugged (or there is a power failure) while the recorder is on,
all the settings will be lost
•
Make sure that you switch the recorder into standby before unplugging the power
cord
•
Press
7
then restart playback
•
The operation you want to perform is prohibited by the disc. This is not a
malfunction
•
The operation you want to perform is prohibited by the player. This is not a
malfunction
•
If you connected this recorder to other Pioneer products using the
CONTROL
IN/OUT
jacks, point the remote control at the other component to use (
page 12
)
•
Set the remote control to the same ID number as the recorder (
page 87
) (When
the batteries run down, the remote mode is automtically reset to 1)
•
Use the remote within its operating range (
page 8
)
•
Replace the batteries (
page 8
)
•
Make sure that the volume of the amplifier/receiver or TV is not set to minimum
•
There is no sound when the picture is paused, or during scanning (even forwards
at regular play speed) or slow motion play. Press
3
PLAY
to resume regular playback
•
DTS discs can only be played if this recorder is connected to a DTS decoder or
DTS compatible amplifier/receiver. If you have connected a suitable decoder, also
make sure that the
Recorder Setup > Audio > DTS Output
setting is
On
.
•
Some 96kHz discs do not output audio through the digital outs. In this case,
switch the input of your amplifier/receiver to analog
•
Check the audio cable connections (
page 15, 17, 18
)
•
Check that the cable plugs are clean
•
If the video signal from the external component is copy-protected, you cannot
connect via this recorder. Connect the component directly to your TV
Содержание DVR-7000
Страница 1: ...DVD Recorder DVR 7000 Operating Instructions 4 7 ...
Страница 103: ......
