It is necessary to apply the surface preparation solution and the rain
repellent in less than 15 minutes after the clean step. If the application
takes more than 15 minutes it will cause the windshield to stain.
Treat the windshield as follows:
1.7.1
Use a new pair of disposable gloves.
1.7.2
Prepare the surface preparation solution, refer to the product
manual in the master kit, surface seal.
1.7.3
Put approximately 1/4 of the surface preparation solution on to
some gauze pads to make them moist. Do not let the surface
preparation solution drip from the gauze pads.
1.7.4
Use the gauze pads and apply the surface preparation solution to
the windshield glass surface as follows:
1
Start at the center of windshield glass surface.
2
Apply a thin film of the surface preparation solution in
straight line strokes.
3
Overlap the straight line strokes.
4
If necessary, apply more surface preparation solution to
make the gauze pads moist.
5
Apply from the center to the edges. Do not apply to the
taped edges.
6
Apply a thin film of the surface preparation solution around
the edges.
7
Discard the gauze pads.
8
Do not use the gauze pads used at the edges to apply the
surface preparation solution to the center.
9
Immediately remove excess surface preparation solution
with dry gauze pads.
10
Let the applied layer of surface preparation solution dry for a
minimum of 5 min.
1.7.5
Do 1.7.4 again to apply a second layer of surface preparation
solution, master kit.
1.7.6
Apply the rain repellent coating solution, master kit as follows:
1
Use a new pair of disposable gloves.
2
Prepare the coating solution, master kit, refer to the product
manual in the master kit, surface seal.
3
Put approximately 1/3 of the coating solution, master kit on
to some gauze pads to make them moist. Do not let the
coating solution, master kit drip from the gauze pads.
Section 2 - Aircraft Servicing
Ground Servicing Guide
Report No: 02484
Issue date: Nov 30, 2020
Page 2-4-13
PC24-A-A15-12-0050-01A-250A-A
