2.3.5
Post Deicing Inspection
After deicing / anti-icing a visual inspection, for contamination, must be done at these
locations:
−
Air data probes
−
Wing leading edges, upper and lower surfaces, spoilers, aileron surfaces including the
wing seals
−
Horizontal stabilizer leading edges, upper and lower surfaces, elevator surfaces
particularly at the balance horns
−
Vertical stabilizer and rudder side surfaces
−
Flaps
−
Upper fuselage
−
Fuel tank and vents
−
Landing gear.
2.3.6
Pre Takeoff Check
After the deicing / anti-icing procedure and before takeoff, the pilot in command must do a pre
takeoff check to make sure all critical surfaces are free of contamination.
1
Visually examine these critical areas, make sure there is no frost on the:
−
Wing leading edge and upper surface
−
Windshield.
2
Do a check to make sure the:
−
Flaps fully extend and retract
−
Flight controls, operate smoothly through their full range of movement.
Section 2 - Aircraft Servicing
Ground Servicing Guide
Report No: 02484
Issue date: May 13, 2020
Page 2-8-11
PC24-A-A15-12-0071-00A-260A-A