4
Use the gauze pads to apply the coating solution, master kit
to the windshield glass surface as follows:
1
Start at the center of windshield glass surface.
2
Apply a thin film of the coating solution, master kit with
short, circular movements.
3
If necessary, apply more coating solution, master kit to
make the gauze pads moist.
4
Apply from the center to the edges.
5
Apply a thin film of the coating solution, master kit with
short, circular movements around the edges. Do not
apply to the taped edges.
6
Discard the gauze pads.
7
Do not use the gauze pads used at the edges to apply
to the coating solution, master kit to the center.
8
Let the applied layer of coating solution, master kit dry
for a minimum of 5 minutes.
5
Do step 1.7.6.4 again to apply a second layer of coating
solution, master kit.
6
Discard the used paper wipes, and the disposable gloves.
7
If no heat curing will be done, do the steps that follow:
1
Use a new pair of disposable gloves.
2
Use clean paper wipes to wipe off the unwanted haze
and residue of the coating solution, master kit.
3
Use as many clean paper wipes as necessary until all
the haze and residue has been removed.
4
Wash the windshield with deionized water and dry it
with clean paper towels
5
Discard the used paper wipes, and the disposable
gloves.
1.7.7
Heat cure the windshield as follows:
1
Carefully put a sheet of protective film from the curing kit,
surface seal in position on the windshield.
2
Make sure that the protective film aligns to the edges of the
windshield.
3
Secure the protective film with masking tape to the four
corners of the windshield.
4
Put the heating blanket from the curing kit, surface seal in
position on the windshield.
Section 2 - Aircraft Servicing
Ground Servicing Guide
Report No: 02484
Issue date: Nov 30, 2020
Page 2-4-14
PC24-A-A15-12-0050-01A-250A-A
