PIAGGIO NRG POWER PUREJET, Руководство по ремонту, Страница: 94 / 248

- Use the specific tool to remove any bearings left
on both crankcase halves.
Specific tooling
001467Y006 Pliers to extract 20 mm bearings
001467Y007 Driver for OD 54 mm bearing
Refitting the crankshaft bearings
- This operation requires assembly by temperature
- Dip the bearings in oil bath when this is still cold.
Avoid contact between bearings and container.
- Use an appropriate amount of oil (approx.1 l)
- Gradually heat the container with a thermal gun
until the oil temperature reaches approx. 150°.
- Check the temperature using a multimeter provi-
ded with thermal probe
N.B.
IF THE BEARINGS WERE IMMERSED INTO
HOT OIL, THEY WOULD BE IMMEDIATELY
DAMAGED.
- Place the crankshaft on the special support
- Alternately introduce the 2 bearings to insert
them home.
- If required, use a specific pipe to ensure their in-
sertion.
N.B.
THIS OPERATION SHOULD BE PERFORMED
QUICKLY AND WITH PRECISE MOVES. OTH-
ERWISE, START OVER.
Specific tooling
020265Y Bearing fitting base
Engine
NRG Power Purejet
ENG - 30